Spare 20 metre V2 Wind masthead cable – (V2 THREE WIRE)
£33.53
Replacement 20 metre mast cable for the Clipper, Target and Cruiser V2 three wire wind systems.
You may also like...

Spare Shunt 200 Amp
50 millivolt 200 Amp shunt for Clipper BM-2 and BM-2 Compact

HF Antenna power adaptor
HF3 has the power supply for the HF antenna built in since 2005 (Red label on back of radio chassis).
If you want to use the antenna for another receiver you will need this power adaptor to provide 12V.

Depth Transducer (with 7 metre cable)
Spare 150kHz depth transducer with 7 metre cable

HF3W SSB Receiver
TARGET HF3/P & HF3/W
The Target HF3 is a masterpiece of R. F. engineering covering the entire spectrum between 30Khz to 30Mhz. For those new to single side band reception the unit comes complete with everything needed to ‘get on the air’ including a comprehensive instruction manual which includes a list of useful marine frequencies.
Controls on the front of the receiver change reception mode, from a narrow filter for SSB reception to a wide filter which enables high quality audio signals to be heard from broadcast stations around the world. They also control ten memory channels to store your favourite frequencies.
The large, clear liquid crystal display shows the precise frequency tuned to and there is no need for constant ‘correcting’ with the tuning knob so often associated with SSB signals as the receiver
is fully synthesised.
TARGET HF3/P
The Target HF3/P has a fixed level audio output to connect to third party weatherfax software. The receiver is supplied complete with a basic long wire antenna, 12 volt power cable and instruction book.
TARGET HF3/W
The HF3/W is complete with CD software and interface cable for connection to a PC sound card. The software enables reception of weatherfax pictures, Radiotelex weather forecasts and Navtex. Simply install the software, plug in the supplied cable to the receiver output and PC sound card to receive weatherfax pictures and forecasts from around the world.
Requires PC Windows XP to 10.

20 metre wind extension cable (for 5 wire masthead unit)
20 metre long extension cable for MK1 – 5 wire wind instruments.
Note there are two versions available:
Version 1 has PLUG for display connection.
Version 2 has TERMINAL BLOCK for display connection.