Accessories and Spare Parts
Clipper BM-2 battery monitor
The BM-2 is designed to monitor performance of 12 volt lead acid battery systems with capacities of up to 999 Amp hours. It is supplied complete with a precision 200 AMP shunt and a prefabricated cable assembly to enable simple DIY installation. The unit continuously monitors voltage, current (charge or discharge), number of amp/hours (charge or discharge), the batteries state of charge and the time to charge or discharge. This information leads to more efficient use of the battery, which can enhance battery life and reduce the risk of failure.
You may also like...
HF3W SSB Receiver
TARGET HF3/P & HF3/W
The Target HF3 is a masterpiece of R. F. engineering covering the entire spectrum between 30Khz to 30Mhz. For those new to single side band reception the unit comes complete with everything needed to ‘get on the air’ including a comprehensive instruction manual which includes a list of useful marine frequencies.
Controls on the front of the receiver change reception mode, from a narrow filter for SSB reception to a wide filter which enables high quality audio signals to be heard from broadcast stations around the world. They also control ten memory channels to store your favourite frequencies.
The large, clear liquid crystal display shows the precise frequency tuned to and there is no need for constant ‘correcting’ with the tuning knob so often associated with SSB signals as the receiver
is fully synthesised.
TARGET HF3/P
The Target HF3/P has a fixed level audio output to connect to third party weatherfax software. The receiver is supplied complete with a basic long wire antenna, 12 volt power cable and instruction book.
TARGET HF3/W
The HF3/W is complete with CD software and interface cable for connection to a PC sound card. The software enables reception of weatherfax pictures, Radiotelex weather forecasts and Navtex. Simply install the software, plug in the supplied cable to the receiver output and PC sound card to receive weatherfax pictures and forecasts from around the world.
Requires PC Windows XP to 10.
Wind vane kit
Spare wind vane assembly with fixings and illustrated fitting instructions
For Clipper, Target, Cruiser and Wireless, Tactical masthead units
IMPORTANT – Select correct type for your model
Clipper / Target / Cruiser Version 1 – five wire mast unit
Clipper / Target / Cruiser Version 2 – three wire / Wireless / Tactical mast unit
Paddlewheel + spindle
Spare paddlewheel and spindle, simple fit for all Clipper, Target and Cruiser Logs.
Wind Anemometer Cup Kit
Spare anemometer cup assembly with fixings and illustrated fitting instructions
Select correct type for your model
Type – Clipper, Target, Cruiser Wind Version 1 – five wire mast head units*
*If your mast unit has or had a red coloured wind vane fin you require the Version 1 – five wire type.
Type – Clipper, Target, Cruiser Wind Version 2 – three wire mast units, Wireless and Tactical masthead units*
*If your mast unit has or had a red coloured wind vane fin you require the Version 1 – five wire type.
Depth Transducer (with 7 metre cable)
Spare 150kHz depth transducer with 7 metre cable
